RACE Deco Kit for RXP-X & GTR-X White

Complete RACE Decoration Kit from RIVOT Racing for Jet Ski Seadoo RXP-X 260, 300 and GTR-X in White and Blood Red

ref. KDSRRBLA

PLEASE SAVE THE CUSTOMIZATION FIELDS AT THE BOTTOM OF THE PAGE

The deco kits are made with ultra-resistant vinyl, as well as reinforced microbead glue and a special 100µ thick protection. High Definition Printing.

- Provides optimal protection for your hull.
- Under the effect of heat, the vinyl takes shape and adapts to all the contours of your Jet-Ski for greater ease of installation.
- Maintains the intensity of its colors for a long time even with strong UV exposure.

ENLARGE IMAGE in HD:

Tools needed:
- A cutter or scissors
- A can of degreaser
- A hair dryer or a heat gun (be careful of high temperatures with the heat gun)
- A raclette
- A soft, clean cloth

Before starting to install your kit, make sure you are in favorable conditions: in a clean and dry place, temperature around 20°C and have enough time. Allow 1 to 2 hours to install a kit.

Step 1: Preparation of the supports
Clean your fairings several times using a degreaser. It is essential to remove all traces of glue and grease from the plastics, even if they are new (silicone residue), because the glue will not adhere properly. Be careful, products such as gasoline, white spirit or "WD40" type products can be effective on certain types of glue, but they are very greasy. Remember to degrease several times if you use them. Do not use window cleaners or acetone.

Step 2: Positioning and gluing
Position the sticker to identify its location. Always start a collage by roughly presenting the piece to be glued. Small tip: the glue used is in the form of micro beads, this means that you can affix and remove your sticker several times without it sticking permanently. Once you have chosen the right location, you will simply have to scrape the sticker starting from its center, which will have the effect of piercing the micro beads and thus triggering the polymerization bonding process. Once the sticker is in place, eliminate air bubbles by pressing very firmly outwards with a clean cloth and/or a squeegee and/or felt.

Tip: If the piece you are working on has significant relief, consider heating the sticker slightly with a hair dryer, because under the effect of heat the vinyl will take its shape and will be easier to apply.

Step 3: Finishing touches
Finally, once the entire kit is in place, warm each piece slightly using a hair dryer and apply significant pressure to the entire kit, paying particular attention to sensitive areas, always using a soft cloth or squeegee, from the inside to the outside.

Step 4: Imperative!
Let your decoration kit rest for 2-3 days, no navigation!!! After the pressure is applied, the glue must have time to polymerize and adhere to its new support.

Tip: If you notice an air bubble, do the following:
Prick the bubble firmly in its center using a pin, keep it pressed, heat
the bubble with the hair dryer and then remove the pin while continuing to heat. The hot air
The expanded fluid will then evacuate on its own and the bubble will disappear.